Tech Specs: Generator Controller Module (Genset/AMF)
Product Identification
Product Type: Automatic Genset Controller / AMF (Automatic Mains Failure) Module
Function: Automated start/stop, control, protection, and monitoring of a single generator set
Manufacturer: (Not specified, but similar to SmartGen, Deep Sea, or ComAp models)
Electrical Specifications (Power)
Power Supply: 8 to 35 VDC (Wide range to withstand engine crank voltage drops)
Power Consumption: < 3W (Typical)
Connection Type: 4x Multi-pin plug-in connectors (rear-mounted)
Display & Interface
Display Type: Graphic LCD Display (e.g., 128x64 or 132x64 pixels), typically backlit
Panel Controls: 9 front-panel buttons (Power, START, STOP, +, -, OK, Up Arrow, Down Arrow, Back/Return)
Indicators: LCD icons for alarms, status, and measurements
Inputs & Outputs (Typical Configuration)
Digital Inputs: 4-6 configurable digital inputs (for E-Stop, Low Oil Pressure, High Coolant Temp, Remote Start, etc.)
Analog Inputs: 2-4 configurable resistive inputs (for Oil Pressure, Coolant Temp, and Fuel Level sensors)
Relay Outputs: 4-6 configurable relay outputs (e.g., Fuel Solenoid, Start Motor, Stop Solenoid, Pre-heat, Alarm)
AC Sensing (Generator): 3-Phase + Neutral (V, Hz)
AC Sensing (Mains/Utility): 1-Phase or 3-Phase (V, Hz)
Current Sensing: 1 or 3-Phase CT (Current Transformer) inputs
Measurements & Protection
Engine: RPM, Oil Pressure, Coolant Temp, Fuel Level, Battery Voltage, Run Hours, Charge Alternator Voltage
Generator: Voltage (L-N, L-L), Frequency (Hz), Current (A), Power (kW, kVA, kVAr), Power Factor (PF)
Protections: Over/Under Speed, Low Oil Pressure, High Coolant Temp, Over/Under Voltage, Over/Under Frequency, Overcurrent, Fail to Start/Stop, Emergency Stop, Battery Over/Under Voltage
Physical & Environmental Data
Mounting: Panel Mount (secured by 4 front screws)
Case Material: High-Temperature ABS/Polycarbonate
Sealing (Front Panel): IP65 (when installed with the correct gasket)
Sealing (Rear Panel): IP20
Operating Temperature: -25°C to +70°C